solidwork, Draft Analysis
Using the settings in draft analysis, you can verify draft angles on model faces or you can examine angle changes within a face.
To apply a draft analysis to verify draft angles:
Open the model, then click Draft Analysis on the Mold Tools toolbar, or click Tools, Draft Analysis.
Under Analysis Parameters, do the following:
Select a planar face, a linear edge or an axis to indicate the Direction of Pull.
Note the draw direction. To change the draw direction, click Reverse Direction . You can also use the handle in the graphics area to reverse direction.
I tried to make a fillet in solidworks but i accidentally put the radius of my fillet slightly too high so two nearby fillets would collide with each other and solidworks crashed. I just input bad parameters I didn't actually try to use the fillet..
BalasHapusSolidworks